Top plate casters (also known as "flat plate casters") are one of the most common types of caster wheels, providing a simple, but straight forward installation method. They are usually installed on flat structures, for example wooden boards. However, some guidelines must be followed when considering the installation of castor wheel, so that the installation of castor wheels can ensure long life and trouble-free operation. Before we discuss installation considerations, the following criteria should be considered to ensure the right castor wheel is selected:
Assuming the right castor wheels Perth has been selected; let's move on to the 6-step castor wheel installation guide
Step 1: prepare the structure
Prepare the surface and structure - It is important that the structure in which the casters are to be installed is rigid enough to support the load. For example, if you were previously mounting casters on a non-mobile item (for example, a table), it is assumed that the casters will focus on the surface area of the top plates, such as the entire surface area. Is the opposite. Structure (i.e. wooden base). It may therefore be necessary to “build” the corners with extra wood to increase strength.
For larger tools, or for relatively weekend wood, consideration should be given to providing additional support to the casters in the centre or on the outer edge to prevent the wood structure from flexing.
Step 2: Mark the place where you are going to fix the castor
Marking - Place the top plate on a wooden board, and place it in the desired position (make sure it is not too close to the edge of the wood). Now, using a pencil, mark each of the four holes on the wood.
The arrangement of the casters is extremely important. The casters should normally be located symmetrically +/- 1 mm, unless other positions are designed, although alignment is extremely important to ensure that no stress is applied to the caster forks, which can buckle the caster forks during the "turn”.
Step 3: Make pilot holes with the help of hand drill
Pilot Holes - Once the "bolt hole" is out of the market and the alignment and condition are checked, the next step is to drill the pilot holes. Using a drill piece approximately 50% of the diameter of the bolt, a pilot hole should be drilled for each bolt whole position.
Step 4: install castors as per your requirements
Install casters - casters can now be positioned and screwed into the device. Screw / bolt strength is important, and we recommend using grade 8.8 for optimal performance.
Step 5: check the mobility of your installed castors
Check the manoeuvre - Now that the casters are installed, you should check the equipment to make sure all the wheels are working as needed. Particular attention should be paid to any wheel that is not in full contact with the floor surface, in which case packing shims should be used to improve pack height.
- As per the research report, global CPG Digital Marketing Market is expected to reach us$ 60.6 billion by the end of the year 2027